Inch tape measure reading7/31/2023 Millimeter or 1mm: The smallest metric measurement on the blade is the millimeter.This measurement can be found at every 10th millimeter marking. Centimeter or 1cm: This measurement is indicated by the longest line on the metric side of the blade and a large number.This measurement is located at every 10th centimeter line. Decimeter or 1dm: The one-decimeter marking is normally shown at a red numeral of 10.On some tape measures, the centimeters will begin at one following the meter marking. Meter or 1m: The one-meter marking is located at the one 100th centimeter marking or 10th decimeter marking.Read a tape measure’s incremental marks for the metric system. Sixteenth or 1/16”: The shortest line on the imperial measurements indicates a 16th of an inch and doesn’t normally have a fractional representation.This line may also be indicated by a fractional representation. Eighth or 1/8”: The second shortest line on the imperial measurements is listed as an eighth of an inch.It may also be indicated with a fractional representation, similar to the half inch. Quarter or ¼”: The mid-size line is the third longest and the third shortest on the typical tape measure.Some measuring tapes only show the line as a measurement indicator, while others will show the line and the fractional representation of the measurement. Half or ½”: The second longest line is the half inch measurement.This line is indicated by a large number sitting to the left of the line. Inch or 1”: The inch measurement is the longest vertical line on the imperial half of the blade.This measurement is normally in a black box with a small triangle or arrow pointing to the inch line that it falls on. Foot or 1’: The foot measurement shows up on the 12th inch and is written as 1F.A tape measure with both inches and centimeters usually has the imperial measurements in red on the top of the blade, while the metric measurements are in black on the bottom of the blade. In the United States, the imperial measurement system is normally used on a tape measure, though some models may have both the imperial and the metric system. Read a tape measure’s incremental marks for the imperial system. Blade: The technical term for the tape itself, the blade is used by pulling the tang, stretching the across the distance to be measured, and reading the numbers and symbols on the face of the blade. Lock: The button on the front of the housing locks the tape in place when pressed, preventing the tape from being pulled out further or retracting.When reading the tape measure, the tang indicates zero.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |